Calcium carbonate grinding mill operating manual

Calcium carbonate grinding mill is the main equipment needed in the grinding process, so what problems should you pay attention to during the use? The following will give you an inventory of the seven aspects that need to be paid attention to during the operate process:

1. During the use of the calcium carbonate grinding mill, there should be a fixed person responsible for the care, the operator must have a certain level of technology. Before the installation, the operator must carry out the necessary technical training to understand the principle performance of the mill and familiar with the operating procedures.

2. Since the calcium carbonate grinding mill is generally working outdoors, the broken material is some large ore. Therefore, the operator of the mill must always pay attention to it. It is strictly forbidden to enter the machine and find that it will be stopped immediately, otherwise grinding roller and grinding ring will be damaged.

3. In the use of the calcium carbonate grinding mill, it is necessary to strictly control the moisture of the material. Materials with too high water content can easily cause the fine powder in the mill to be too viscous and occupy the abrasive body, which seriously affects the quality and yield of the product.

4.Must be in accordance with the prescribed standards to do the feeding, otherwise it will cause uneven particle size, thick, fine, affecting the grinding effect.

5. It is necessary to grasp the adjustment of the air volume, and adjust it according to the fineness and output requirements; whether the air volume is too large or the air volume is too small, it will have a bad influence on the effect of the Raymond mill after the mill.

6. After the grinding machine is used for a period of time, it should be repaired. At the same time, the wearing parts such as the grinding roller and the blade should be repaired and replaced. The grinding roller device should be carefully checked before and after use to see if there is looseness. Phenomenon, whether the grease is added.

7. Master the correct method of stopping the machine. Stop the feeding before stopping the machine. After a while, wait until the material in the machine room has no remaining material. Then the power can be cut off. After stopping the grinding work, stop the fan motor. In order to blow off the residual powder.

E-mail : shuguangzhongji@163.com

Cel : 0086-13523465141