How to do the check work of calcium carbonate grinding mill

For the calcium carbonate grinding mill, to ensure the ideal production,we need do the check work before the start-up.This inspection is to find out some factors that may cause equipment failure in time to ensure the smooth progress of production. At the time of inspection, there are mainly five aspects. Here is to analyze these aspects.

1. Lubrication

Before the start of the calcium carbonate grinding mill, the lubrication condition is checked to ensure sufficient lubrication. This is the premise to ensure the efficient operation of the equipment. If the lubrication is insufficient, the parts such as the grinding ring and the grinding ring in the equipment will be worn more.

2. Firmware situation

The calcium carbonate grinding mill has some fasteners, which should be checked before starting the machine, such as bolts. If the bolts that fix the mill to the foundation loosen and are not found in time, then vibration will occur in the production. Such phenomena may even cause the machine to detach from the base, which is not only unfavorable to production, but also extremely harmful to the safety of workers.

3.Conveyor belt situation

The operation of the calcium carbonate grinding mill requires the assistance of the conveyor belt. It needs to be checked before starting the machine. If it is found to be damaged, it should be replaced immediately. If there is oil on the conveyor belt, wipe the oil with a rag.

4.Protective device

This device is very important for the calcium carbonate grinding mill, and it is related to the safety problems in production. Therefore, it must be checked before starting the machine, and the abnormal phenomena should be solved in time to prevent accidents.

5. Grinding room

Check the grinding chamber. If there is oil ore or debris, the operator should clean it up to ensure that the machine cavity starts.

E-mail : shuguangzhongji@163.com

Cel : 0086-13523465141