workflow of feldspar ball mill

Feldspar is also commonly called p

otash

feldspar, and potassium feldspar series are mainly feldspar and striped feldspar. Feldspar can be selected by a ball mill for grinding according to the specific grinding fineness. The workflow is described below.

The material is uniformly fed into the first chamber of the mill by the feeding device through the hollow shaft of the feeding material. The chamber has a step liner or a corrugated liner, and various grinding media are contained therein. When the cylinder rotates around the horizontal axis at a certain rotation speed, the medium and the raw materials contained in the cylinder are attached to the cylinder liner by the centrifugal force and the friction force, and are taken away by the cylinder, and brought to a certain extent height. When its own gravity is greater than the centrifugal force, it will drop off or roll off the inner wall of the cylinder, and the material will be hit and ground due to the impact force.

After the material reaches the rough grinding in the first bin, it enters the second bin through the single-layer partition plate. The bin is embedded with a flat liner with steel balls inside to further grind the material. During the rotation of the mill, the grinding body also produces sliding and rolling, so that grinding action occurs between the grinding body, the lining plate and the material, so that the material is ground. Since the feed end continuously feeds the new material, the material difference between the feed and the discharge end material can force the material to flow, and the axial thrust of the impact material when the abrasive body falls and the air flow in the mill also force the material to flow. Then, the powder is discharged through the discharge jaw to complete the grinding operation.

Our company has nearly 30 years of manufacturing experience and welcomes customers in need to contact us.

E-mail : shuguangzhongji@163.com

Cel : 0086-13523465141