The workflow about orthoclase Raymond mill

OrthoclaseRaymond mill is also a potassium feldspar Raymond mill, which is an important equipment for grinding feldspar with industrial mill technology.

The main components of orthoclase Raymond mill are composed of main engine, blower, ultra-fineness analyzer, finished cyclone powder collector, bag filter and connecting duct pipe. The following describes its workflow.

In the main body of the K-feldspar Raymond mill, the high-pressure spring with 1000-1500 kg pressure is fastened on the grinding roller hanger. After starting work, the grinding roller rotates around the main shaft and is pressed against the grinding wheel under the action of high-pressure spring and centrifugal force. The ring rolling, the pressure is 1.2 times higher than the Raymond mill under the same dynamic conditions, so the output is greatly improved. When the milled feldspar enters the grinding chamber, it is shoveled by a blade and sent to the grinding roller and the grinding ring for rolling. After rolling, the powder is brought into the analysis machine along with the circulating air of the blower, and the qualified fine powder enters the whirlwind with the airflow. The powder collector is the finished product, and the large particle potassium feldspar falls back to regrind. The circulating air is returned to the blower and the above process is repeated. The residual wind is purified by the bag filter. When the wear of the grinding roller and the grinding ring reaches a certain level, the length of the high pressure spring is adjusted to maintain a constant rolling pressure between the grinding roller and the ring, thereby ensuring Stable production.

The above is the introduction of the K-feldspar Raymond grinding workflow, welcome to visit our company.

Tel : 0086-371-67666667 E-mail : shuguangzhongji@163.com Cel : 0086-13523465141