How to disassemble the bearing of calcium carbonate grinding mill

Nowadays

is gradually becoming an important equipment in the grinding industry.Well,as an important part of calcium carbonate grinding mill,bearing plays an important part in the working process.For calcium carbonate grinding mill, the installation, use and disassembly of equipment need to follow strict steps. For the bearings of the grinding machine, we need to pay attention to correct ways when we need to disassemble them.

First of all, when disassembling bearings, we should pay attention to the selection of disassembly tools and the correct disassembly steps and sequence, strictly abide by these can effectively prevent the damage of the accessories around the bearings. When disassembling, first turn the bearing device out, then check the end clearance of the grinding roller bearing, remove the roller sleeve and shaft assembly from the grinding roller head, and pull the inner ring of the bearing out of the grinding roller shaft after one disassembly of the fittings. Then the grinding roller bearing seat is removed from the grinding roller shaft. At this time, the upper and lower outer rings of the bearing remain in the bearing seat. The appropriate tools are selected to pull the outer rings of the bearing out, so that the disassembly step of the bearing is completed.

Factory Address: Longjiang West Road, Shangjie District, Zhengzhou City

Contact number: +86-371-67666660 676667

Mobile phone: 0086 13523465141

After-sales Service Department: 0371-67666667