How to maintain the blower

Whether the material processed by the calcium carbonate grinding mill can be delivered depends on the normal operation of the blower. The blower is an important component of the calcium carbonate grinding mill. The maintenance procedures for the blower are as follows:

1. Check the tightening of each part of the blower and whether the positioning pin is loose.

2. There is no leakage or oil leakage inside the blower body.

3. There should be no scaling, rust and peeling inside the blower body.

4. Pay attention to whether the lubricating oil cooling condition is normal, pay attention to the quality of the lubricating oil, and always listen to the blower.

5. Pay attention to whether the unit works under the specified working conditions.

6. The overload of the blower is sometimes not immediately displayed, so pay attention to the increasing trend of intake and exhaust pressure, bearing temperature and motor current to determine whether the machine is operating normally.

7. Before disassembling the blower, measure the fit dimensions, make a record, and mark the other parts to ensure the assembly and maintain the original fit requirements.

8. After the new or overhauled blower, the fuel tank should be cleaned and put into operation according to the use procedure. It is recommended to replace all the lubricating oil after the operation.

E-mail : shuguangzhongji@163.com

Cel : 0086-13523465141