How to solve low production of calcium carbonate grinding mill

Calcium carbonate grinding mill is a general-purpose milling equipment used in the field of industrial milling. After years of development and improvement, calcium carbonate grinding mill is also constantly upgrading and still the main force in the field of milling.

In the production process, if you encounter the following common faults, you can check it to avoid affecting the normal production.

Fault one: no powder or no powder, low yield

The cause of the malfunction:

(1) The locker is not adjusted well, and the seal is not strict, causing the powder to suck up.

(2) The blade is worn out and the material cannot be shovel.

Solution:

(1) Check and adjust the lock of the locker and find that the air leak should be scraped.

(2) Replace the new blade.

Fault two: the finished powder is too thick or too fine

The cause of the failure:

(1) The blade of the analyzer is seriously worn and cannot be graded.

(2) The fan air volume is not appropriate.

Solution:

(1) Replace the length of the blade and turn off the air volume of the small fan to solve the rough.

(2) If it is too fine, the inlet air volume should be increased.

E-mail : shuguangzhongji@163.com

Cel : 0086-13523465141