If you are looking for related products or have any other questions, you can call the company service hotline at any time, or click the button below to communicate with us online!
Perlite is a special variant of acid-sprayed rock that produces new insulation materials and expanded perlite products. The perlite raw sand can be used as a filler in rubber and plastic products, pigments, inks, synthetic glass, heat-insulating bakelite and some mechanical components and equipment after crushing and grinding by crusher and micro-grinding. After being expanded, perlite has the characteristics of light density, low thermal conductivity, good chemical stability, wide temperature range, low moisture absorption capacity, non-toxicity, odorlessness, fire resistance and sound absorption.
When
the perlite micropulver mill
for processing perliteis in operation, the main motor drives the main shaft and the turntable through the reducer, and the roller at the edge of the turntable drives the grinding roller to roll in the grinding ring. When the perlite is ground, the perlite ore is broken into small particles by the crusher and then sent to the storage bin by the hoist. Then the perlite particles are evenly sent to the micro-grinding through the vibrating feeder and the inclined feeding pipe. On the bulk disc on the upper part of the turntable, the perlite particles are impacted by the grinding ring in the raceway falling into the grinding ring, and the processing of the rolling roller and the grinding three-layer loop becomes perlite powder. The fan sucks the external air into the micro-grinding main body through suction, and brings the crushed perlite powder into the classifier. The rotating impeller in the classifier recirculates the coarse perlite powder, which meets the requirements. The powder enters the cyclone dust collector with the airflow and is discharged from the lower discharge valve to be the final perlite ultrafine powder.
Because perlite is relatively light, many customers respond to us. When adding materials to the micro-grinding, there is a problem that the material is thrown from the inlet. For this kind of problem, the solution given by Shuguang Heavy Industry is: through our technical means, the feed inlet is adjusted to form a partition between the material in the micro-grinding main machine and the feed inlet, reducing perlite from feeding. The phenomenon of the mouth thrown.
Tel : 0086-371-67666667
E-mail : shuguangzhongji@163.com
Cel : 0086-13523465141
http://www.sg-shredder.com
Relevant articles
TEL:0086-13523465141
0086-371-67666660
FAX:0086-371—68125111
Email:shuguang_mill@163.com
Address:No.104,Gongye west road,Shangjie district,Zhengzhou City,Henan China